GST200-2 Control Panel

GST200

The GST 200-2 single loop and two loop addressable fire detection control panel is packed with features that are not usually associated with smaller and medium systems. The GST 200-2 provides a high quality solution at exceptional value. By utilizing advanced GST Protocol, the system is compatible with the complete range of GST intelligent detectors, Sounders, Call Points, Interfaces, including gas extinguishing control. The GST 200-2 is manufactured and certified to EN54 parts 2 and 4 and to BS5839 Part 4. The GSTDef2.1 programming facilities enables advanced and complex cause and effects to be programmed with ease, including phased and cascade evacuation scenario. The GST zonal indication and control facility allows the operator to manually intervene, with evacuation and control of each zone, including control of all plant equipment under an alarm condition.

☆ Standard : EN54 Part 2/4 ; BS5839 Part 4
☆ Approvals : LPCB, CPD
☆ Main Input Voltage : 220/230 ± 10% VAC 50/60 Hz
☆ Input Current Rating : 0.500A,Fuse: 2A delay
☆ Operating Temperature : 0°C- 40°C /95% relative humidity
☆ Protection : IP 30
☆ Application : Indoor installation
☆ Programming : Laptop using GST Defining Software/P-9930
☆ Zone Capacity : 30 Zones programmable
☆ Loop Parameter : 1 loop expandable to 2 with LC200 card
☆ Loop Capacity : 477; Loop 1:235; loop 2:242(Address)
☆ Loop Topology : Class A or B
☆ Loop Voltage : 24 VDC Nominal (21-27 VDC)
☆ Loop Current : 0-300mA
☆ Loop Length/Cable : 1.00mm²-800m-Full Load

☆ Listed to LPCB standard
☆ 2 Loop capacity-477 Addressable Point
☆ 8×18 Graphical LCD Display
☆ 30 Zone indication including manual intervention and control
☆ 3 programmable alarm output
☆ Positive Alarm Signal (PAS) Pre-alarm
☆ Maintenance report of dirty detector
☆ Networkable with all GST Intelligent Fire Alarm panels
☆ Programmable form PC by GSTDef2.1
☆ History log 999-events capacity in non-volatile memory
☆ Test Facility-Silent Mode
☆ Device Start/Stop Mode
☆ Device Enable/Disable
☆ RS485 Repeater Output (Max. 10)
☆ Advanced user friendly programming software including ‘Fuzzy Logic’
☆ Optional RS 232 Colour Graphics Software, Printer and Pager Interface
☆ Optional RS485 Network Card
☆ Optional Panel Printer